CCNA4 Module 1 ( updated oct 12 2008 )

CCNA4 v4.0 download(updated 19/7/2008) <

Take Assessment - EWAN Chapter 1 - CCNA Exploration: Accessing the WAN (Version 4.0)

1	At which two layers of the OSI model does a WAN operate? (Choose two.) Physical Layer Data Link Layer Network Layer Transport Layer Presentation Layer Application Layer
2	Why is the call setup time of a circuit-switched WAN implementation considered a drawback? Routing protocols are incompatible with this function. It restricts the communication sent to voice traffic only. A telephone must be used to initially start transferring data. Data cannot be transferred until a circuit has been established.

3	Which networking device is typically used to concentrate the dial-in and dial-out traffic of multiple users to and from a network? core router access server Frame Relay switch ATM switch
4	What can cause a reduction in available bandwidth on a cable broadband connection? smaller cells number of subscribers committed information rate distance from the central office of the provider

5	Which three WAN devices can be found in the cloud? (Choose three.) ATM switches core routers CSU/DSU Ethernet switches Frame Relay switches repeaters
6	Which statement is true about data connectivity between a customer and a service provider? Normally the CSU/DSU is the designated demarcation point for the service provider but not the customer. The segment between the demarcation point and the central office is known as the "last mile." The local loop is the segment between the CSU/DSU and the serial port on a router. Putting data on the local loop is the responsibility of the DTE.

7	What are two advantages of an analog PSTN WAN connection? (Choose two.) low cost availability traffic encryption available bandwidth support for voice and video
8	Which two devices are commonly used as data communications equipment? (Choose two.) modem router CSU/DSU ISDN switch Ethernet switch

9	For digital lines, which device is used to establish the communications link between the customer equipment and the local loop? CSU/DSU Frame Relay switch ISDN switch modem PBX switch
10	A U.S. company requires a WAN connection used only to transfer sales data from individual stores to the home office. All transfers will occur after business hours. The required bandwidth for this connection is estimated to be less than 38 kbps. Which type of connection requires the least investment for this company? ATM ISDN analog dialup T1 Leased Line

11	Which switching type will allow the communication devices in the provider network to be shared and only allocated to an individual subscriber during data transfer? circuit-switched dedicated switched lines frame-switched packet-switched
12	Which three features are identified with Frame Relay connections? (Choose three.) CIR DLCI DSLAM PVC SPID 53-byte cells

13	Which term describes a device that will put data on the local loop? DLCI DTE DCE BRI PRI
14	Which statement is true about the differences between a WAN and a LAN? WANs generally support higher bandwidth than LANs support. A WAN link typically traverses shorter geographic distances than a LAN link traverses. A WAN often relies on the services of carriers, such as telephone or cable companies, but a LAN does not. All WAN implementations generally use the same Layer 2 protocol but there are many accepted LAN Layer 2 protocols in use.

15	What three terms are associated with ISDN PRI? (Choose three.) DLCI circuit switching packet switching data bearer channels switched virtual circuits time-division multiplexing

16	Which statement about WAN protocols is correct? ATM differs from other WAN protocols in that it uses variably sized packets. Most WAN protocols use HDLC or a variant of HDLC as a framing mechanism. The frame header consists of the frame check sequence and cyclic redundancy check. ISDN differs from Frame Relay, HDLC, and ATM in that it is packet-switched rather than circuit-switched technology.
17	Which statement is true of the functionality of the layers in the hierarchical network model? The purpose of the access layer is to provide very high bandwidth communications between network devices. Most security screening to prevent unauthorized entry to the network happens at the core layer. Untrusted external connections are segmented from the rest of the network at all three levels. The core layer uses high speed equipment to provide policy-based connectivity. The distribution layer aggregates WAN connections at the edge of the campus.

18	Which packet-switched WAN technology offers high-bandwidth connectivity capable of managing data, voice, and video all on the same infrastructure? Time Division Multiplexing (TDM) metro Ethernet Integrated Services Digital Network (ISDN) Public Switched Telephone Network (PSTN)
19	A company needs a WAN connection that is capable of transferring voice, video, and data at a minimum data rate of 155 Mbps. Which WAN connection is the best choice? X.25 DSL ATM ISDN BRI ISDN PRI

20	Which WAN technology uses a fixed payload of 48 bytes and is transported across both switched and permanent virtual circuits? ATM ISDN Frame Relay metro Ethernet
21	What type of connectivity is established when VPNs are used from the remote site to the private network? PVCs DLCIs tunnels virtual circuits dedicated Layer 2 links

22

What is an advantage of packet-switched technology over circuit-switched technology? Packet-switched networks are less susceptible to jitter than circuit-switched networks are. Packet-switched networks can efficiently use multiple routes inside a service provider network. Packet-switched networks do not require an expensive permanent connection to each endpoint. Packet-switched networks usually experience lower latency than circuit-switched networks experience.